Firmware Updates¶
Adapter Firmware Update¶
Download the OFED IB adapter firmware from the Mellanox site http://www.mellanox.com/page/firmware_table_IBM .
Obtain device id:
lspci | grep -i mel
Check current installed fw level:
mstflint -d 0002:01:00.0 q | grep FW
Copy or mount firmware to host:
Burn new firmware on each ibaX:
mstflint -d 0002:01:00.0 -i <image location> b
Note
If this is a PureFlex MezzanineP adapter, you must select the correct image for each ibaX device.
- The difference in the firmware image at the end of the file name:
- _0.bin (iba0/iba2)
- _1.bin (iba1/iba3)
Verify download successful:
mstflint -d 0002:01:00.0 q
Activate the new firmware:
reboot the image
Note
The above 0002:01:00.0
device location is used as an example only. Validate your device location using the lspci
command.
Mellanox Switch Firmware Upgrade¶
This section provides manual procedure to help update the firmware for Mellanox Infiniband (IB) Switches. You can down load IB switch firmware like IB6131 (image-PPC_M460EX-SX_3.2.xxx.img) from the Mellanox website http://www.mellanox.com/page/firmware_table_IBM and place into your xCAT Management Node or server that can communicate to Flex IB6131 switch module. There are two ways to update the MLNX-OS switch package. This process works regardless if updating an internal PureFlex chassis Infiniband switch (IB6131 or for an external Mellanox switch.
Update via Browser¶
This method is straight forward if your switches are on the public network or your browser is already capable to tunnel to the private address. If neither is the case then you may prefer to use option two.
After logging into the switch (id=admin, pwd=admin)
Select the “System” tab and then the “MLNX-OS Upgrade” option
Under the “Install New Image”, select the “Install via scp” URL: scp://userid@fwhost/directoryofimage/imagename
Select “Install Image”
The image will then be downloaded to the switch and the installation process will begin.
Once completed, the switch must be rebooted for the new package to be activate
Update via CLI¶
Login to the IB switch:
ssh admin@<switchipaddr>
enable (get into correct CLI mode. You can use en)
configure terminal (get into correct CLI mode. You can use co t)
List current images and Remove older images to free up space:
show image
image delete <ibimage>
(you can paste in ibimage name from show image for image delete)
Get the new IB image using fetch with scp to a server that contains new IB image. An example of IB3161 image would be “image-PPC_M460EX-SX_3.2.0291.img” Admin can use different protocol . This image fetch scp command is about 4 minutes.
image fetch ?
image fetch scp://userid:password@serveripddr/<full path ibimage location>
Verify that new IB image is loaded, then install the new showIB image on IB switch. The install image process goes through 4 stages Verify image, Uncompress image, Create Filesystems, and Extract Image. This install process takes about 9 minutes.
show image
image install <newibimage>
(you can paste in new IB image from "show image" to execute image install)
Toggle boot partition to new IB image, verify image install is loaded , and that next boot setting is pointing to new IB image.
image boot next
show image
Save the changes made for new IB image:
configuration write
Activate the new IB image (reboot switch):
reload